Trying to connect to MQTT in Home Assistant but not much is happening

[ollybowman]

Trying to connect to MQTT in Home Assistant but not much is happening, i'm pretty sure I've followed everything correctly. I tried it with blynk and that was all working fine. I've installed the mqqtha firmware. This is what is see in the console.

rst:0xc (SW_CPU_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT)
configsip: 0, SPIWP:0xee
clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00,wp_drv:0x00
mode:DIO, clock div:2
load:0x3fff0018,len:4
load:0x3fff001c,len:1044
load:0x40078000,len:8896
load:0x40080400,len:5828
entry 0x400806ac
E (405) esp_core_dump_flash: No core �ff��partition found!
E (405) esp_core_dump_flash: No core dump partition found!
++ STARTING Solar-Tracer-Blynk-V3 v3.0.9 [16]
Restoring configuration from file
++ SETTING UP WIFI
++ Start AP configuration

It seems to repeat that every so often. It's connected to the network, and I can login to the configuration panel over the network, but other than that, not much seems to be happening. I can also see the AP as an available network.

Any help would be much appreciated.

[ollybowman]

Actually, I just built my own configuration and that seems to work.

[Bettapro]

Please share your 'config.h' file.

ESP is booting in config mode so:

• Something is wrong in the WIFI configurations (shouldn't be the case, as you said it's connected)
• Something is triggering the config mode (pin 19 or internal hall sensor)

Standard config file does not trigger config mode using internal hall sensor (disabled by default). You can try this:

1. Un-comment //#define USE_HALL_AP_CONFIGURATION_TRIGGER to enable this feature
2. Build and flash the firmware on your board.
3. Check if the ESP boots as usual or in config mode.