powerbank2

---

PowerBank 2 Click

PowerBank 2 Click demo application is developed using the NECTO Studio, ensuring compatibility with mikroSDK's open-source libraries and tools. Designed for plug-and-play implementation and testing, the demo is fully compatible with all development, starter, and mikromedia boards featuring a mikroBUS™ socket.

---

Click Library

• Author : MikroE Team
• Date : Jun 2020.
• Type : I2C type

Software Support

Example Description

This single chip includes a linear charger, a synchronous Boost with dual output load management and a torch function support.

Example Libraries

• MikroSDK.Board
• MikroSDK.Log
• Click.Powerbank2

Example Key Functions

• powerbank2_cfg_setup Config Object Initialization function.

void powerbank2_cfg_setup ( powerbank2_cfg_t *cfg );

• powerbank2_init Initialization function.

err_t powerbank2_init ( powerbank2_t *ctx, powerbank2_cfg_t *cfg );

• powerbank2_read Read function.

void powerbank2_read ( powerbank2_t *ctx, uint16_t *result );

• powerbank2_read_voltage Read voltage function.

uint16_t powerbank2_read_voltage ( powerbank2_t *ctx, uint16_t v_ref );

Application Init

Initalizes I2C driver and makes an initial log.

void application_init ( void )
{
    log_cfg_t log_cfg;
    powerbank2_cfg_t cfg;

    /** 
     * Logger initialization.
     * Default baud rate: 115200
     * Default log level: LOG_LEVEL_DEBUG
     * @note If USB_UART_RX and USB_UART_TX 
     * are defined as HAL_PIN_NC, you will 
     * need to define them manually for log to work. 
     * See @b LOG_MAP_USB_UART macro definition for detailed explanation.
     */
    LOG_MAP_USB_UART( log_cfg );
    log_init( &logger, &log_cfg );
    log_info( &logger, "---- Application Init ----" );

    //  Click initialization.

    powerbank2_cfg_setup( &cfg );
    POWERBANK2_MAP_MIKROBUS( cfg, MIKROBUS_1 );
    powerbank2_init( &powerbank2, &cfg );
}

Application Task

This example shows the capabilities of the Power Bank 2 Click by measuring voltage of the connected battery. In order to get correct calculations the user should change "v_ref" value to his own power supply voltage.

void application_task ( void )
{
    voltage = powerbank2_read_voltage( &powerbank2, v_ref );

    log_printf( &logger, "Battery voltage: %u mV\r\n", voltage );

    Delay_ms ( 1000 );
    Delay_ms ( 1000 );
}

Application Output

This Click board can be interfaced and monitored in two ways:

• Application Output - Use the "Application Output" window in Debug mode for real-time data monitoring. Set it up properly by following this tutorial.
• UART Terminal - Monitor data via the UART Terminal using a USB to UART converter. For detailed instructions, check out this tutorial.

Additional Notes and Information

The complete application code and a ready-to-use project are available through the NECTO Studio Package Manager for direct installation in the NECTO Studio. The application code can also be found on the MIKROE GitHub account.

---