Reverting back to Original Elegoo Firmware & Software

[Galloant]

Reverting back to Original Elegoo Firmware & Software

Image

If you haven't touched the Klipper Firmware on the MCUs (you haven't actively tried to flash them), but tried to put OpenOrangeStorm on your machine, you'll need to flash the stock image onto the eMMC memory and perform the next steps too.

For the image, visit Elegoos official release repository and download the ZIP file.
This image needs to be flashed to the eMMC via Rufus as described in the Getting Started with OpenOrangeStorm discussion, section Flashing OpenOrangeStorm.

After flashing, reinsert the eMMC onto the board, but don't turn the machine ON yet! Proceed with the next section.

Install/repair stock Klipper version

If you updated Klipper via Fluidd, or did something else where Klipper gives you one error after the other, it's best to use the recovery package to get everything back working again.

Fix package can be downloaded here:
https://drive.google.com/drive/folders/1MpNFKX49odtSycQgL1nVpnnoTToYNCVV?usp=sharing
This is the official download link Elegoo gave me. I know it looks sketchy, but it's save. I would have preferred to upload the package to this discussion, but it's too big.

Extract the contese and copy it to a FAT32 formatted USB drive. Get sure that the directories are as follows:
drive letter:\ELEGOO_UPDATE_DIR\packages

Done that, insert the USB stick into a USB port on the printer, and switch it on. Wait 1-3 minutes.
If everything went well, the machine should now work again.