T Deck Plus cant see other nodes

[jdinky3]

I have a new Tdeck plus and it cant see other nodes and they cant see it.
I have the Tdeck plus and 2 heltec T114s

I have reset the Tdeck and one of the T114s to factory settings and they still cant see each other.
The Tdeck is on firmware 2.7.3
The T114 is on firmware 2.6.11
And they are both on frequency slot 20

[lewisxhe]

#94
#92
#89

I see you said you have set the frequency channel to 20, I believe you have seen the above issue

Please check whether you follow this setting
#94 (comment)

[jdinky3]

I changed both to Frequency Slot 0 as the last comment in #94 said that fixed his but nothing changed for me

[lewisxhe]

@mverch67 I need your help

[mverch67]

@jdinky3

I changed both to Frequency Slot 0 as the last comment in #94 said

There is no frequency slot 0 (in MUI), I guess it's a typo in the comment and should read 20 instead.

[jdinky3]

OK well they are back on 20 and still the same issue

[mverch67]

@jdinky3
Please follow all the steps from #92, especially providing the information from the debug log

[jdinky3]

Hope this works

meshtastic-log-2025-07-23T16-13-15.371Z.log

All is the only link in the Open Serial Monitor that shows any information, info and debug are empty

[lewisxhe]

@mverch67 Please see this log

[mverch67]

The log show two packets sent from T-Deck with channel hash 0x8. Is there also a log on the receiver side?

[jdinky3]

How would i get that?
I would assume ALL would provide everything

[mverch67]

How would i get that?

by connecting your receiving node with a serial monitor in the same way as you did with the T-deck

[jdinky3]

From the heltec T114

meshtastic-log-2025-08-01T12-59-50.602Z.log