QLever UI shows wrong number of results

[divral]

Hello,

I got very confused by this behavior of the QLever UI. So I think it is worth fixing it:

In some cases, when a "LIMIT [int]" clause is added, it says in the UI "[int] lines found", even if there are in fact fewer results.

Example showing "100 lines found" when only 25 lines have been found.

I will make another reply when I find out when exactly this does or does not happen.

[divral]

I noticed that putting a comment after the LIMIT clause causes the number of results to be shown correctly:

Example from before with added comment