Home

Welcome to the betrusted-hardware wiki!

For lack of a better place, here is the DVT hardware validation tracker.

on power, no tuning, board 2_L as measured at battery - 595mW (wifi off), 626mW (wifi scanning)
standby, no tuning, board 2_L as measured at battery - 4.3mA @ 4.2V = 18mW (wifi off), 12mA @ 4.2V = 50mW (wifi scanning)
ship mode, no tuning, board 2_L as measured at battery - 0.07mA-0.03mA (50/50 duty) @ 4.2V. Probably gas gauge.
backlight (keyboard strand) - +134mA at 4.15V = 0.556 watts 100% brightness

Quick Test

SRAM: OK
SPINOR: OK
KEYBOARD: OK
TRNG_AVALANCHE: OK
TRNG_OSC: OK
I2C: OK
RTC: OK
RTC_ALARM: OK
AUDIO: OK; note: firmware unstable after soft-boots
SPEAKER:
VIBE:
JTAG_LOOP: Wires are there, but driver is inserting an extra 1 somewhere in the chain
MEMLCD: OK
COM: OK
REBOOT: OK
WIFI: OK
CHARGER: OK
GASGAUGE: OK
SLEEP_POWER: OK
SLEEP_WAKE: OK
KEYBOARD_WAKE_COMBO: OK - consider introducing 100k pull-downs on sense lines
SHIPMODE: OK - requires ECO
SRAM_SLEEP_RETENTION: OK
EC_SPI: OK
EC_UART: OK
SOC_JTAG: OK
SOC_UART: OK
GYRO: OK (but interrupts not tested)
BACKLIGHT: (kbd OK LCD pending)
USB_BOOST: FAIL - needs work-around PCB for switchover network
USB_DEVICE: OK - works as wishbone target
USB_HOST:
CHARGER_DETECT: OK
VBUS_LEVEL: OK
T_DISCHARGE: OK
ANTIGLITCH: OK
XADC: OK
BITSTREAM_INJECT: