[HW Accel Support]: rpi5-64 (Raspberry Pi 5 64-bit OS) and Pineboard Coral Edge TPU #11708
Replies: 3 comments
-
I tried to add a /etc/udev/rules.d/65-apex.rules file to set mode to 0660 for root:root.
But Frigate is still not willing to find the TPU. Based on the remaining interrupts errors, I guess is that there is still something going on the MSI-X support, but I have never looked into Linux kernels with that kind of debth. |
Beta Was this translation helpful? Give feedback.
-
Interested on @Zaleo80 issue. Also trying to run Frigate with the Pineboard Dual Edge Coral TPU on a RP5 with HASOS |
Beta Was this translation helpful? Give feedback.
-
For what it's worth, I ran into the same issue. Hardware is RPi5 with MCUZone MPDTPU Solution was to switch to kernel8.img instead of the default kernel_2712.img and the apex driver stopped complaining on |
Beta Was this translation helpful? Give feedback.
Uh oh!
There was an error while loading. Please reload this page.
Uh oh!
There was an error while loading. Please reload this page.
-
Describe the problem you are having
When using any Coral M.2 Accelerator A+E Key Frigate Add-On does not start anymore.
Did try with bothe the Dual Edge Coral TPU Bundle from Pineboards and with a different HatDrive and a regular M.2 A+E-Key Google Coral Edge TPU.
As I am not sure where to reported I also reported it here: home-assistant/operating-system#3279
Protected mode is disabled

Version
0.13.2-6476F8A
Frigate config file
docker-compose file or Docker CLI command
https://github.com/blakeblackshear/frigate/blob/dev/docker/rpi/Dockerfile
Relevant log output
FFprobe output from your camera
Operating system
HassOS
Install method
HassOS Addon
Network connection
Wired
Camera make and model
Eufy Indoor Cam 2K Pan & Tilt
Any other information that may be helpful
The /dev/apex_0 device does show up.
Beta Was this translation helpful? Give feedback.
All reactions