tanix w2 pro 不支持

[myallten]

tanix w2 4G+64G model is pro

[myallten]

tvbox:~#./aml-multiboot-setup.sh
Setup multiboot. This will reconfigure your bootloader environment to use a 'boot order' to load boot scripts while booting. The default boot order will be set to:

1. sd,
2. usb,
3. emmc,
4. original boot.

This will change your bootloader environment. By doing so there is always a small risk to 'brick' your box. If you don't have the tools, image and knowledge to fix that, you should reconsider. Personally I have never 'bricked' a box with this script. However ymmv, don't blame me.
Are you sure to proceed? y/Ny
Ok, proceeding
Trying to config u-boot environment storage location... [Ok]
Backupping current u-boot environment to uEnv.bak... [Ok]
Writing boot commands to bootloader...
Done.
tvbox:~#./aml-install-to-emmc.sh

WARNING: This script CAN (soft) brick your TVBOX and is UNSUPPORTED!

This script has not been tested extensively, is not high quality and makes a

lot of assumptions about your bootloader. If your bootloader version fails

to meet any of these assumptions... It will no longer boot from eMMC.

However, in most cases, the box will still be able to boot from a USB flash

drive or USB otg via the Amlogic USB burning tool. You can often use this

method to fix boot problems.

If you don't have the knowledge or tools to unbrick an Amlogic system and

you are very attached to your box, maybe this script isn't for you.

That being said, it works on my full range of boxes, S905, S905X, S905W,

S912, S905X2, S922X, S905X3, S905X4 ans S905W2. I have never bricked one

of my boxes with this script.

But of course, every TVBOX can be different, so your mileage may vary.

Anyway, if you use this script, don't blame me or ask me to fix it

when it goes wrong, you have been warned, you're on your own (and Google).

Current Host disk: [ /dev/sda ]
Target eMMC disk: [ /dev/mmcblk1 ]

Error No multiboot detected. You should setup multiboot first. Run ./aml-multiboot-setup.sh and reboot.
Exit

use :box=tanixw2