SelSameBlock Command not working

[JJeffrey16]

Hello. Great tools, and thanks a lot for providing them. For some reason however, the SelSameBlock command isn't recognised and returns Unknown Command (whether I use the tool bar or type it). The others work fine. I'm using Rhino 6.

[ejnaren]

Hi and thank you.
I can confirm that others are experiencing the same lately after updating rhino and I have not yet located the issue.
I am also very short on time and had hoped McNeel would include them in Rhino 😅
But I will continue to troubleshoot it when I have the chance.

[ejnaren]

Hi again.

Just for general information,
these tools are now included in Rhino 8, out of the box.

In this case you can select a block and use the SelBlockInstanceNamed command.

Best regards :)