the analog sensor does not work in the "counter" mode #2200
Description
Water and gas meters are connected according to this diagram.
In EMS-ESP it was written like this
In the Home assistant I see the meters like this, but they don't count the readings.
I installed pull-up resistors on the GPIO counters
in the open state of the reed switch at the output of the ESP 32 (GPIO 25/26/27) = 3v3, in the closed state = 0v
signal levels on gpio 25 when water is consumed
Soldered a resistor, did not help. In the "counter" mode, the readings are not counted. When setting the GPIO to the "Digital in" mode, the ESP-EMS begins to see pulses and output them to "on / off" No miracle happened
It doesn't work with these settings.
DESCRIPTION
A clear and concise description of what the problem is or the change requested.
REQUESTED INFORMATION
Make sure your have performed every step and checked the applicable boxes before submitting your issue. Thank you!
- Searched the issue in issues
- Searched the issue in discussions
- Searched the issue in the docs
- Searched the issue in the chat
- Provide the System information in the area below, taken from
http://<IP>/api/system
Paste System information here....
TO REPRODUCE
Steps to reproduce the behavior:
EXPECTED BEHAVIOUR
A clear and concise description of what you expected to happen.
SCREENSHOTS
If applicable, add screenshots to help explain your issue.
ADDITIONAL CONTEXT
Add any other context about the issue here.
(Please remember to close the issue when it has been addressed)