diff --git a/content/components/nrf52.md b/content/components/nrf52.md
index ca4ff2cb65..fa67c520f2 100644
--- a/content/components/nrf52.md
+++ b/content/components/nrf52.md
@@ -100,6 +100,29 @@ nrf52:
 
 - **reset_pin** (*Required*, [Pin](/guides/configuration-types#pin)): The pin to use for trigger a hardware reset. This pin should be connected to the MCU's reset line or to a circuit that causes the bootloader to enter DFU mode after reset.
 
+## REGOUT0
+
+Output voltage from the REG0 regulator stage, which powers the GPIO pins when the board operates in high-voltage mode.
+This setting can only be changed a limited number of times, unless uicr_erase is set to true.
+It requires `mcuboot` or `adafruit` bootloader at least `0.9.3`.
+
+### Example Configuration
+
+```yaml
+nrf52:
+  reg0:
+    voltage: 3.3V
+    uicr_erase: true
+```
+
+### Configuration variables
+
+- **voltage** (**Required**, voltage): The desired output voltage - must be one of
+  1.8V, 2.1V, 2.4V, 2.7V, 3.0V, 3.3V.
+- **uicr_erase** (**Optional**, bool): If set to true, the User Information Configuration Registers (UICR)
+will be erased before writing the new voltage setting.
+⚠️ Warning: Enabling this may cause the board to fail to boot if misconfigured. Default is false.
+
 ## See Also
 
 - {{< docref "esphome/" >}}