Default `GT911` configuration of kit `EP-0172`

[rubienr]

Please make the default configuration of the GT911 touch controller publicly available.

• Kit: EP-0172 (MTP2063a-GFF 2.5 EYA-Display).

Unfortunately i ran into the same issue as described by this post: DiveInEmbedded/GT911-Touch-driver#1
During the attempt to swap the XY axis and invert X and Y axis by the controller itself (not as in the example code in the PI Pico firmware) i have overwritten the shipped config and cannot restore the original state.

I would appreciate if somebody can post the bytes dumped from the registers 0x8047 up to 0x8100 of the GT911 GOODiX controller.

Kind regards!

[Fighter19]

These are the config bytes starting from 8040, not related to this kit. (So you'll have to remove a few bytes first)
I don't know if this will help you.
I'm currently investigating an issue on my own, where the GT911 seems to have absolutely no config set and also seems to refuse any new config.
gt911_offset_8040.txt

EDIT: In case anyone is stumbling across this, the GT911 uses a bi-directional INT pin.
Failing to briefly de-assert this pin from host to touch upon reset, will leave the chip in sleep mode.