Amperage Limitation triggers Charging again if stopped through Adapters "setenergy" Parameter or through App #509
Description
Hi,
i have an issue with the adapter since i activated the amperage limitation inside the adapter options.
I did activate it to get a bit of protection for the Main Fuses of our House. The KEBA Firmware option never worked well over wifi.
I use the Adapter to stop Charging at an estimated Percentage with the "setenergy" parameter.
Before activation the behavior was like this:
- if Car Charging was stopped with an App or over the "setenergy" parameter inside the adapter, the Wallbox stopped charging with "state" 5 and stayed like this until charging was manually retriggered.
Since activation of the amperage limit, behavior is like that:
- when triggered over an App or over the "setenergy" parameter inside the adapter, Car Charging is stopped, and the Wallbox goes into "state" 5. After a few seconds, Charging is started again through the Adapter via a new "currtime" Command and the Car starts charging again.
Expected behavior would be, that the Wallbox stays in "state" 5 until Charging is triggered again.