HM-ES-TX-WM: Reed sensor debounce necessary?

[Hans5546]

Hi!
I built the HM-ES-TX-WM and flashed it with the Askin scetch.
The sensor also delivers values, unfortunately these are too large by a factor of about 2.6 ... 3. I have already adjusted the counter constant, but apparently the deviation is not always the same, so this does not lead to the goal.
I run a reed sensor that is attached directly to the gas meter, it is a sensor that fits the meter exactly.
I suspect that the input signal has to be suppressed or debounced somehow. Do you have an idea how this works best? I run the sensor on batteries if that makes a difference.

Thanks a lot for your help!

[jp112sdl]

You can try it with hardware debouncing, (i.e. google for "debounce reed switch")

[Hans5546]

Hello!

I tried it and it seems to work :-)

I simply connected a 100nf capacitor between ground and the input and a additonal resistor with 22kOhm between 3,3V and input.
Since that, the sensor counts excatly.