-
Notifications
You must be signed in to change notification settings - Fork 1
/
geko.ini
49 lines (31 loc) · 1.62 KB
/
geko.ini
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
; Sample config file for geKo
; This is a comment
; Data acquisition hardware configuration
[hardware]
device = Dev1/ai0 ; Device name, e.g. Dev1 (as in Dev1/ai0)
ai0_cal_offset = 0 ; Offset for calibration, default 0
ai0_cal_scale = 1 ; Factor for calibration, default 1
ai1_cal_offset = 0 ; Offset for calibration, default 0
ai1_cal_scale = 1 ; Factor for calibration, default 1
ao0_cal_offset = 0 ; Offset for calibration, default 0
ao0_cal_scale = 1 ; Factor for calibration, default 1
ao1_cal_offset = 0 ; Offset for calibration, default 0
ao1_cal_scale = 1 ; Factor for calibration, default 1
aichans = ai0 ai1 ; Analog input channels, default ai0 ai1
aochans = ao0 ; Analog output channels, default ao0
srate = 15000 ; Sample rate [Hz], default 15000
;-------------------------------------------------------------------------------
; Amplifier configuration (e.g. for MultiClamp 700B)
[amplifier]
ai_factor_cc = 20 ; Amplifier gain in current-clamp
ai_factor_vc = 400 ; Amplifier gain in voltage-clamp
ao_factor_cc = 0.00025 ; pA/V of the Amplifier's command in current-clamp
ao_factor_vc = 0.05 ; mV/V of the Amplifier's command in current-clamp
;-------------------------------------------------------------------------------
[protocol] ; Protocol configuration
version=26 ; IPv6
[user]
name = Aldio Bob Smith ; Spaces around '=' are stripped
email = [email protected] ; And comments (like this) ignored
active = true ; Test a boolean
pi = 3.14159 ; Test a floating point number