Replies: 4 comments 3 replies
-
I've followed the steps on #875 (reply in thread) and the inverter seems to be detected and added to home assistant. |
Beta Was this translation helpful? Give feedback.
-
There are a few entries that are not populated (Battery SoC, Battery SoH, Battery Temp and all BMS values - my battery is an EP11) but most are: ![]() ![]() ![]() ![]() ![]() |
Beta Was this translation helpful? Give feedback.
-
Re #832 (comment): So you no longer have any Unknown registers? |
Beta Was this translation helpful? Give feedback.
-
Did you use |
Beta Was this translation helpful? Give feedback.
Uh oh!
There was an error while loading. Please reload this page.
Uh oh!
There was an error while loading. Please reload this page.
-
I have a recent (2 months) FoxESS installation of panels + inverter + battery system (EP11) and the inverter that was installed is the P3-6.0-E. I looked at the specs and seems to be exactly the same as the H3 line. Not sure if the P3 is specific to specific areas (I'm in Portugal) or a recent product.
I can help test it with this integration if needed.
I've setup the Elfin EW11 and this integration but get the message
Details: Inverter model not supported: 'P3-6.0-E'
Beta Was this translation helpful? Give feedback.
All reactions