Support Details: Inverter model not supported: 'P1-6.0-E' #914
Replies: 3 comments 3 replies
-
More info: `C:\modpoll>modpoll.exe -m tcp -p 502 -a 247 -t 3 -0 -1 -c 16 -r 11000 192.168.1.30 Protocol configuration: MODBUS/TCP, FC4 -- Polling slave... |
Beta Was this translation helpful? Give feedback.
-
Additional info:
Hope this helps! |
Beta Was this translation helpful? Give feedback.
-
Follow this procedures and changed H1-G2 to P1 and it's working now. |
Beta Was this translation helpful? Give feedback.
Uh oh!
There was an error while loading. Please reload this page.
Uh oh!
There was an error while loading. Please reload this page.
-
Hi,
Recently I had a FoxESS inverter installed but I cannot use this modbus integration.
The message is the following:
Error connecting to your adapter or inverter. Ensure the adapter is properly configured and is correctly wired to your inverter (see the setup link above), then try again. Details: Inverter model not supported: 'P1-6.0-E'
Log:
Did not recognise inverter model 'P1-6.0-E' ([20529, 11574, 11824, 11589, 8224, 8224, 8224, 8224, 0, 0, 0, 0, 0, 0, 0])
Can you please add support for the P1 model?
Basically it is a H1-G2 inverter.
Thank you
Beta Was this translation helpful? Give feedback.
All reactions