Anycubic Photon M7 MAX - .pm7m file problem

[mryellowhammer]

After exporting the file to .pm7m format and trying to print it on the Anycubic Photon M7 Max printer, a message appears saying: "File parameter, incorrect layer thickness". The procedure was as follows:

1. I imported the .pm7m print test file from the USB stick attached to the printer that had previously printed without a problem to UVTool 5.0.9.
2. I converted it to from .pm7m to .pm7m file again using UVTool 5.0.9.
3. Tried to print it in my printer and I got an error as follow that popup on the screen "File parameter, incorrect layer thickness"

I tried it on the attached file by Anycubic because before I've been trying to convert other types of files and it didn't work eather. So something is going wrong during conversion in UVTool 5.0.9 and I do not know what. Any ideas?

[sn4k3]

2. I converted it to from .pm7m to .pm7m file again using UVTool 5.0.9.

Why you doing that? Do not reconvert, simply save it.

[sn4k3]

I need a file that you used and known failed, as well the original source.

[mryellowhammer]

Two files:

1. sample_Anycubic_Photon_Workshop.pm7m - file generated by Anycubic slicer. After printing is finished bed retracs around 20mm
2. sample_UVtools_5_10.pm7m - file converted in UVtools 5.10 doesn't retrac the bed and after last layer was UV expose bed doesn't even release it from FEP

sample_Anycubic_Photon_Workshop.zip
sample_UVtools_5_10.zip

[sn4k3]

Can't find anything to justify that.
I will replicate two more fields in a new patch to see if it helps, if not i'm cluless.

[mryellowhammer]

I'm just thinking but maybe this problem is related to the fact that after converting the file in UVTool, resin usage approximation is changed. Look at the photo below. Maybe Anycubic interprets it as an unfinished print...

[sn4k3]

I think that is informative only, you can edit that directly on file and see if it helps.