Possible to retract before moving to tower?

[theophile]

I'm getting stringing between the print and the tower (and zits on the print), I think because the slicer's pre-move retraction settings aren't applied to the tower code. Is it possible to add a retraction before the move to prevent this?

[spegelius]

Pre-move retractions are applied before moving to the tower. You can check this from the gcode, look for line ; TOOL CHANGE, there should be retraction before that line.

[theophile]

Unfortunately there is not.

[spegelius]

Filaswitch follows the retraction settings of the sliced gcode so make sure you have the wanted retraction enabled for the extruders