Delta-P V2
Custom Extruder for MK3 3D printer
- Dragon hotend only
- MMU2 only (or run w/o runout sensor)
- requires custom firmware or custom sensor. see: https://www.prusaprinters.org/prints/3091-delta-p-extruder
- you will need to send the following gcode commands to calibrate for the gear reduction:
M350 E16
M92 E415
M500
These files are currently in development. Don't expect everything to be perfect.
June 21, 2021
added:
brace_stock_frame
clamp_stock_frame
renamed:
brace --> brace_bear_frame
clamp --> clamp_bear_frame
Updated toolholder to allow sensor connector to plug into the back of the sensor. Requires soldering the 3 pin header on the other side of the pcb. Improves wire routing.
April 18, 2021 Created repo and uploaded files
May 12, 2021 Fixed reduced x build volume. should pass self check now.
- Moved fan fwd so it no longer contacts x carriage during auto home
- Trimmed back cable management guides on carriage
- Modified pinda clamp