Replies: 3 comments 4 replies
-
|
What controller and firmware are you using. |
Beta Was this translation helpful? Give feedback.
-
|
ich benutze einen Arduiono |
Beta Was this translation helpful? Give feedback.
-
|
GRBL1.1? |
Beta Was this translation helpful? Give feedback.
-
|
ja |
Beta Was this translation helpful? Give feedback.
-
|
Instead of using the pause button, there is a button called "Open door" which you can try. If I remember correctly it will pause the machine and turn off spindle. Another alternative is to run GRBL in laser mode. Check the GRBL documentation how that works. |
Beta Was this translation helpful? Give feedback.
-
|
Danke ! das werde ich testen ! Hier meine kleine Maschine, die ich mit UGS fahre : |
Beta Was this translation helpful? Give feedback.
-
IMG_9277.mov |
Beta Was this translation helpful? Give feedback.
Uh oh!
There was an error while loading. Please reload this page.
-
Guten Tag,
ich benutze keine Spindel sondern eine Spritzpistole an meiner Maschine. Wenn ich "Pause" drücke, hält die Maschine an, spritzt aber weiter. Kann ich den Befehl "M5" für das Stoppen des Spritzens irgendwie einbauen. So dass die Maschine anhält und sofort das Spritzen beendet ?
Beta Was this translation helpful? Give feedback.
All reactions