FAQs
This is caused as both CS pins are enabled at the same time and the CS for the LoRa chip may be enabled first so it will crash. To avoid this, use the Linker SubGHz option within the LoRa Relay app.
This is caused due to an incorrect configuration of the UART pins, which enables the communication with the Flipper. Using the firmware file published in the Flipper Add-On Marauder section, you must be able to correctly save the logs of Marauder.
You can find the 3D STL files for 3D printing in the below links:
You can always contact our Support Team by sending us a request on our Contact Us page
Thank you for reading our Wiki!
- How do Magnetic Stripes work?
- MagSpoof Flipper Add-On
- Understanding MagSpoof Flipper Add-On
- First steps with the Flipper Add-On MagSpoof
- Example
- Marauder - Marauder Spoof's technologies
- Flipper Add‐On: Marauder
- Flipper Add‐On: Marauder Spoof
- Understanding Flipper Add-On: Marauder and Flipper Add-On: Marauder Spoof
- First steps with Marauder
- Marauder App
- How does Flipper Add-On SubGHz' technologies work?
- Flipper Add‐On: SubGHz
- Understanding Flipper Add‐On: SubGHz
- First steps with Flipper Add‐On: SubGHz
- What is RS485?
- What is the Modbus Protocol & How Does It Work?
- Requirements
- Menus description
- How to build a packet manually and send it
- How does Flipper CAN Bus work?
- Flipper Add‐On: CAN Bus
- Understanding Flipper Add‐On: CAN Bus
- First steps with Flipper Add‐On: CAN Bus
- Flipper Add‐On: Ethernet
- Understanding Flipper Add‐On: Ethernet
- First steps with Flipper Add‐On: Ethernet