Helper interface and CLI to interact with luxafor products.
git clone [email protected]:fmartingr/pyluxafor.git
cd pyluxafor
python3 setup.py install
Create UDEV rule in /etc/udev/rules.d/60-luxafor.rules with the following content
# add Luxafor LED flag
SUBSYSTEMS=="usb", ATTR{idVendor}=="04d8", ATTR{idProduct}=="f372", MODE:="0666"
Reload udev configuration files
sudo udevadm control --reload && sudo udevadm trigger
Reinsert the Luxafor LED light.
Pyluxafor provides the luxa
command to interact with the USB led in the same way as the library
does, with some helper commands to convert colors between RGB/Hex.
# Converts between hexadecimal to decimal color notations
luxa hex2dec 00ff00
luxa dec2hex 255 255 0
# Set a flag with a fixed color
luxa set --led=all #ff0000
# Fade
luxa fade --led=all --speed=10 #00ff00
# Strobe
luxa strobe --led=front --speed=100 --repeat=10 #0000ff
# Wave
luxa wave --wave 3 --duration=100 --repeat=200 #ff0000
# Pattern
luxa pattern --repeat=2 2
# Turns off the luxafor
luxa off
# Using the conversion helpers in one command
luxa set $(luxa dec2hex 255 0 0)
from luxafor import luxafor
lux = luxafor.Luxafor()
# Led types
luxafor.Leds.ALL
luxafor.Leds.FRONT
luxafor.Leds.BACK
luxafor.Leds.LEDn # Where n is a number from 1 to 6, refer to the class
# Set a basic color
# From: off, yellow, green, blue, magenta, cyan, red, white
lux.set_basic_color('green')
# Set a static color
lux.set_color(<red>, <green>, <blue>, <led>)
# Fade to a color
lux.fade(<red>, <green>, <blue>, <led>, <speed>)
# Strobe
lux.strobe(<red>, <green>, <blue>, <led>, <speed>, <repeat times>)
# Wave
# Wave types:
# 1: Short wave
# 2: Long wave
# 3: Overlapping short wave
# 4: Overlapping long wave
lux.wave(<red>, <green>, <blue>, <led>, <wave type>, <duration>, <repeat times>)
# Enable predefined pattern
# Patterns from 1 to 8
lux.pattern(<pattern number>, <repeat>)
# Turn off the luxafor
lux.turn_off()