New Features:
- Update Codebase to Marlin 2.1.2.7 (Thanks @stklcode !)
❤️ I would like to once again thank everyone involved! You are great! ❤️
Known Issues:
- The built-in leveling of the 4MAX Pro does not work yet. Use the 4-point-easy leveling and mesh leveling via the special menu instead.
- The Mega Pro BMP Laser feature is not (yet) supported. Use the M3 Spindle/Laser feature instead.
- The Nozzle temperature can only be set over 260°C via gcode and not the Touchscreen. This issue can not be fixed.
- The gcode filetransfer via Wifi is pretty slow due to to hardware limitations.
How to Install:
- Follow the Beginner's Guide which is also available in german as "Einsteiger Leitfaden".
- Read the FAQ which can also be found in the Wiki.
- If you own a MEGA S or MEGA PRO, set your Bed size in your Slicer to these values.
- Use Cura, PrusaSlicer or xLoader to flash the Firmware to your Printer.
Important: Be sure to select "LOAD FW DEFAULTS" and "SAVE EEPROM" via Special Menu after updating! *
*You may not have to reset everything.
However, the prerequisites for this are difficult to tell, which is why I wrote something this topic here in english and here in german.
Contributors
stklcode