Skip to content

Using PT100 Themperature Sensor with MKS Sbase

Jump to bottom Edit New page
ulysse31 edited this page May 9, 2018 · 1 revision

Welcome to the MKS-SBASE wiki!

I found a solution to use PT100 Temperature Sensor with PT100 amplifierboard from E3D with MKS Sbase boards.

As in Smoothieware Documentation mentioned
http://smoothieware.org/pt100
edit your config.

Connect the amplifier Board 5V pin to Sbase Pin 2 on J2 (SPI Pin with 3,3V), The amplifier Board Ground pin to your Sbase Thermocouple – pin for AGRND and the Signal pin to Sbase Pin 1.30 or 1.31 on EXP1.

Enjoy PT100 watching your Temperature!

PS: If you are searching for Pin 2 on J2, here’s an hint (thanks to Makerbase reply) :

Add a custom footer
Add a custom sidebar
Clone this wiki locally