Table of contents
node: lts/erbium (v12.*)yarn: 1.22.4 +
Take CentOS as an example
Install nvm ( version control system for nodejs )
wget -P /root/ --tries=10 --retry-connrefused --waitretry=60 --no-dns-cache --no-cache https://raw.githubusercontent.com/nvm-sh/nvm/master/install.sh bash /root/install.sh . /root/.nvm/nvm.shInstall nodejs
NODE_VERSION=erbium nvm install --lts=$NODE_VERSION nvm alias default lts/$NODE_VERSION nvm use default
Verify nodejs and npm versions
node -v # v12.*.* npm -v # 6.*.*
Install yarn
npm install -g yarn
Install the project dependency under the root directory, with
package.jsonin the same place.yarn install
After those steps, please just wait until the installation is complete.
Under the root directory, with package.json in the same place.
yarn run mock: Use the mock interface of rap2yarn run dev: To use the actual interface, you can copyconfig/config.yamltoconfig/local_config.yaml, and replace theservervalue with the correct address.yarn run build: Build packages and then you can hand over the contents of the generated dist directory to the back end.
- Preparation before development
- Directory structure
- Develop a new resource page
- BaseList introduction
- BaseTabList introduction
- BaseDetail introduction
- BaseDetailInfo introduction
- BaseStore introduction
- FormAction introduction
- ModalAction introduction
- ConfirmAction introduction
- StepAction introduction
- FormItem introduction
- Action introduction
- Menu introduction
- Route introduction
- I18n introduction
