-
Notifications
You must be signed in to change notification settings - Fork 458
P330 Battery Intelligent board
Function
Variants
Parts
Programming
External interfaces
Service interfaces
Board view
Schematics
DJI Intelligent Flight Battery for P2 is a 5600mAh, 11.1V LiPo 3S battery, supporting up to 25 minutes of flight time. The battery also has built-in sensors and LEDs that let you know the status and remaining power.
The battery management system chip communicates with Naza Flight Controller using SMBus protocol, which in turn is deviced from I2C.
There are multiple versions of the board.
Marking | Overview |
---|---|
DJI07 V13 20131028 |
Marking | Amt. | Pkg. | Function | Specification |
---|---|---|---|---|
BM3328 | 1 | 2-4 Cells Lithium Battery Gas Gauge Management and Protection IC | ||
TPS1AH FDMS | 4 | N-channel power MOSFET; markings uncertain |
Chips | Firmware | Description |
---|---|---|
unknown | m1100 |
Connectors on the board are:
Marking | Overview |
---|---|
P- High Current Soldering Pads | Power output wire of the battery |
B- High Current Soldering Pads | Battery cells connection |
TS Soldering Pads | Temperature sensor connection |
6-pin Balancer and comms con. | Contains connections for cells balancing, plus wires for the communication interface connected to Naza FC. |
The following service pads exist on this board:
Marking | Overview |
---|---|
TODO |
Top of a DJI07 V13 board:
Bottom of the DJI07 V13 board:
No schematics available.
This page is created by drone enthusiasts for drone enthusiasts.
If you see a mistake, or you know more about specific subject, or you see an area for improvement for the wiki - create an issue in this project and attach your patch (or describe the change you propose).